-
Flap Switch & Audio
My AOA Pro is in a Lancair 360 installation and not yet calibrated.
On startup I get the message "landing gear" and "AOA pass" and the AOA audio flows through a PS Engineering PMA4000.
When depressing the flap switch, the green donut toggles on or off but there is no audio "Flaps".
What could I have done incorrectly?
Thanks
-
If it is a ProII you should hear Flaps when the donut turns on. It does not say flaps when the donut turns off.If you have the old Pro AOA I dont think it says flaps.