Figured it out. When flying to adjust the A/P parameters, go to SET, then AP/FD. Along the bottom of the screen is a button for each parameter to adjust while flying!
Type: Posts; User: RKURRLE
Figured it out. When flying to adjust the A/P parameters, go to SET, then AP/FD. Along the bottom of the screen is a button for each parameter to adjust while flying!
AFS 5600 x 2, Dynon autopilot. Need to go through the autopilot tuning flowcharts in the AFS manual page 73. When flying to do this, can I bring up a split screen like on the Dynon HDX, that shows...
I have the Dynon autopilot. Without auto trim for pitch, is there a display prompt on the AFS 5600 to tell me when to manually adjust pitch trim to neutralize the pitch force on the servo?
I have twin AF 4500s. Plane has been flying 4 years. In the last few months I am getting intermittent low fuel pressure, low oil pressure, and high oil temperature reading with audio warning. ...
Hi Rob
I use the AOA on all landings. I like gadgets and think it would be neat to have the airspeed callout.
Hi Rob
I would us it during landing phase. Ideally you could set an airspeed below which you get airspeed callout every few seconds. Would be nice to be able to select airspeed when audio starts...
I have dual 4500's. I just flew with a friend who has the MGL Odessey and it has an audio that calls out airspeed bellowed a pre-determined airspeed. Seems like a great idea for landing so you can...
When flying approaches with the autopilot coupled and the min alt set to DH, the autopilot levels off at the DH. Works great with the audio "minimums". Is there a way to fly with the autopilot...
Rob
I talked to you sometime ago about traffic from the GTX 330 on the 4500 map. I find when turning, the Garmin 430 displays the traffic accurately, but on the AFS4500 the traffic lags -ie, is...
I am flying aerobatics in my RV-7. When I land, I find the g reading on the left shows a line above 3 gs, but no reading of the max g recorded during the flight. Is there a way to display the max g...
OK - I lowered the landing override and now the audio works too good. It is "angle angle push" on takeoff and on landing including the rollout! Explain how the AFS uses the landing override number...
Thanks - I found it in the calibration AOA section and will lower it. _Bob
Hi Rob
Is that a value in the calibration page under AOA? I am not at the airplane now, but will look tomorrow. What is the "landing override value"? I always like to understant the why. ...
Have 2 4500's. AOA is calibrated and display on the 4500 works great. I have no audio "angle angle push" at 115% of stall. The display graphic is correct at 115% of stall, but no audio. The audio...
Thanks Alan
That makes sense - mine must be using the default values. I thought maybe after I found the peaks when leaning, the colors would be relative to that - ie, 50 degrees rich of peak...
The EGT bars change as the engine is leaned. What are the meaning of the different colors. Thank you.-Bob
Hi Rob
Two quick questions on my dual 4500's in my RV-7:
1. Periodically the audio states "check fuel computer". What is triggering the message since I have plenty of fuel on board?
2. ...