In the end it was not the wiring and it was not menu configurations. The software on my Dynon SV-XPNDR-261 was out of date. It was so out of date that it would not receive information from the...
Type: Posts; User: 483RV
In the end it was not the wiring and it was not menu configurations. The software on my Dynon SV-XPNDR-261 was out of date. It was so out of date that it would not receive information from the...
Still thinking it is a configuration issue instead of a wiring issue - I am using the ACM install manual and the AF-5000 Pilot's guide to configure menus. In the ACM Installation manual on pg 41...
Thanks Jonathon. I went ahead and upgraded to the 472 and got it installed today. I only tested it on the ground - will have to test fly when it is a bit less windy than today. On the ground pulled...
I forgot to mention that several times I have seen a yellow pop-up warning on my AFS screens that says "No ADSB Pos"
The warning has only stayed on for about 10 seconds and then disappears on its...
RV-7A with an Advanced panel -2 AFS 5600, Garmin GTN650.
Transponder is SV-XPNDR-261, ADSB module is the 470 and GPS signal is configured from GTN-650 to feed the system.
My adsb is intermittent...
Dynon recently posted Technical Service Bulletin 104808-000 regarding the need to replace SV-AP-Panel/V autopilot control panels below serial#4270 or manufactured before 6/2017. I pulled my panel...
Just bought an RV-7A with an Advanced panel -2 AFS 5600, Garmin GTN650. The panel was put in the plane a long time ago but no one ever really flew it much so its functionality is lightly tested.
My...