Results 1 to 3 of 3

Thread: AF-Pilot standard panel mount

Hybrid View

  1. #1

    AF-Pilot standard panel mount

    Can we get the dimensions for the area behind the panel required for the standard mount?
    Looks like a standard hole with standard screw spacing. Height and width should be standard also.

    Just need to know how far 'forward' it goes....

    Thanks!

  2. #2
    Member
    Join Date
    Mar 2010
    Location
    Austin, TX
    Posts
    88
    Hi recapen,

    I used a combination of this and this to help with my layouts and hole spacing/drilling with good results.

    Dimensions for the 2-1/4" round face AF-Pilot:
    Face of the unit to the back of the aluminum enclosure: 5-3/8" (Note 1)
    Face of the unit to the back of the plastic pitot/static block: 6-1/8" (Note 2)

    Notes:
    1 - Allow for an additional 2-1/2" for a standard DB-25 connector w/ shell and associated wires from the rear of the aluminum enclosure. This could possibly be as tight as 2-1/4" but could pose challendges w/ wire chafing and insertion/removal/securing of the DB-25 connector itself.
    2 - Allow room for appropriate pitot/static connectors into the plastic block. Note that 1/8" NPT is used and should be hand-tightened followed by 1/2 additional turn to avoid cracking the block.

    Good luck,
    /\/elson

  3. #3
    Thanks a bunch!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •