Results 1 to 6 of 6

Thread: Cable Harness Question

  1. #1
    Senior Member
    Join Date
    Mar 2010
    Posts
    127

    Cable Harness Question

    Any significance to why the orn/pur and orn/grn wires are twisted together and the orn/brn is by itself? Since these are just digital inputs and not serial I was a little surprised to see them twisted.
    Bob Leffler
    N410BL - RV10 - Flying
    http://mykitlog.com/rleffler

  2. #2
    Advanced Flight Systems, Inc.
    Join Date
    Mar 2010
    Posts
    568
    Bob, are you sure you aren't looking at the two wires from the engine connector (37-pin) that are for the Amps shunt sensor?
    ---
    Trevor Conroy
    Technical Support
    Advanced Flight Systems
    Support@Advanced-Flight-Systems.com

  3. #3
    Senior Member
    Join Date
    Mar 2010
    Posts
    127
    Yes, I'm sure..... Both of my main harnesses are the same.



    bob
    Bob Leffler
    N410BL - RV10 - Flying
    http://mykitlog.com/rleffler

  4. #4
    Advanced Flight Systems, Inc.
    Join Date
    Mar 2010
    Posts
    568
    In that case, there is no reason why they are twisted.
    ---
    Trevor Conroy
    Technical Support
    Advanced Flight Systems
    Support@Advanced-Flight-Systems.com

  5. #5
    Junior Member
    Join Date
    Nov 2011
    Posts
    1
    But then if there is no such big reason then why are most electric wires twisted?

  6. #6
    Advanced Flight Systems, Inc. Rob Hickman's Avatar
    Join Date
    Mar 2010
    Posts
    1,029
    Stein purchases the orange wire already twisted together.
    Rob Hickman
    Advanced Flight Systems Inc.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •