Rob:
The original request / questions were about:
1) Connecting the IBBS Pin 2 “Battery Info” to the AFS 5500 Exp. Cable Connector Pin 13 “Volts2”.
I went ahead and did that. The IBBS as well as the AFS indications appear to be working / displaying properly.
2) The AGL, altitude above ground, does not work. Looking for guidance on where to start troubleshooting.
This is still a problem. Still looking for guidance.
3) I connected a GDL-82 Pin 21, “Fail” switch, to the AFS 5500 Main Cable Pin 8 “input #3”.
Still need guidance on how to activate an audible and or display message “UAT Fail”.
Apparently, I had a typo in my email address in the original web site request for information. I sent the corrected address to Don, and asked that he resend his response.p to the corrected address. I have not received a response to that.
Thank you.
Byron Covey
Last edited by Byron Covey; 07-09-2019 at 07:52 AM.
Do you have the HRTERRAIN folder on the USB drive and is synthetic vision working properly? Post a picture of your CHECK -> ABOUT page, the bottom shows what GPS is feeding that data.
SET -> Hold CAL -> Inputs -> Set input #3 Usage to Generic and label it "UAT Fail"