It looks like it was only displaying on the EFIS screen wired to the NavWorx, this should fix it.
Rob Hickman
Advanced Flight Systems Inc.
I have dual 4500s and using the ADS600-B. I've never been able to get N-numbers to display. I've installed the latest firmware for both the 4500s and the ADS600-B. Is there something else you have to enable to get them to display? I realize that not all traffic will display N-Numbers, but I should at least see them for traffic flying in/out of SeaTac.
Same set up. In the Phoenix area I get a few N numbers but not many. As time has gone by I see more but a very low percentage . The local
training facility has recently added ADSB so we see them now as well. I would say that about 90 of the traffic shown here is W/O N#s. More are showing up though as time goes by. Larry
Make sure you get the latest release from Ken. He has made some tweaks to the ADSB in December.
There isn't anything to configure to get the N#s to display. However, the other aircraft has to have ADSB out for you to see them. My experience in the Midwest is that it's hit or miss. Some days I see a large percentage and on other days, I don't. I can tell you it's nice for meeting up with fellow RV'ers in the air. At least then you know where your ADSB enabled friends are located.
bob