v14 wasn't ready to release for Sun-N-Fun but the next posted release of v12 software will have support for the GRT EIS serial parsing. We are dropping the v13 release because its overshadowed by v14's feature set.
Thanks for everything so far, Shawn.
I have installed the latest software and trying to configure the settings and I have a couple questions.
1. What input to the EIS4000 is being used for Gearbox temp?
- I have nothing connected to the OAT input (EIS4000 pin 22) and I see -50 on both the EIS and AFS, so I wonder if that is the one being used.
- I am currently using Aux 3 for Gearbox temp, and there seems to be no way to change what input to use in the AFS menu. (?)
2. Is Aux 5 and 6 usable?
- I can only seem to configure some things with Aux 1-->4, But I am using 5 of 6 aux inputs on the EIS.
- If no, will it be in the future?
All of these are good, and looking pretty cool:
-MAP on Aux1
-Fuel pressure on Aux4
-Fuel flow
-Tach
-Oil temp
-Oil Pressure
-Coolant temp
Thanks,
Jeff
We are receiving air, carb, oil temperatures from the GRT it doesn't define a gearbox.
The AF-5000 doesn't read the OAT from the GRT as it already has a source for this data.I have nothing connected to the OAT input (EIS4000 pin 22) and I see -50 on both the EIS and AFS, so I wonder if that is the one being used.
The EFIS can be configured for the following inputs:
Aux 1: Cool Temp, Manifold, Tank 1, Tank 2, Fuel PSI
Aux 2: Cool Temp, Manifold, Tank 1, Tank 2, Fuel PSI
Aux 3: Cool Temp, Manifold, Tank 1, Tank 2, Fuel PSI
Aux 4: Cool Temp, Manifold, Tank 1, Tank 2, Fuel PSI
Aux 5: Cool Temp
The data doesn't see to define aux 6.