Im hooking up the afs gps to the expansion connector. One diagram shows drawing power from pin 1 of expansion receptacle, another shows drawing power from main cable pin 6, the old oat terminal. Is either/both correct?
Im hooking up the afs gps to the expansion connector. One diagram shows drawing power from pin 1 of expansion receptacle, another shows drawing power from main cable pin 6, the old oat terminal. Is either/both correct?
Last edited by rvdave; 01-22-2015 at 01:26 PM.
Dave Ford
RV10
Ok I see p 237 shows 8v out @ 350 ma for pin 1. This should be ok for afs gps?
Dave Ford
RV10
If you purchased your EFIS in the last 15 months you have REV 7 hardware.
http://www.advanced-flight-systems.c...al%20V3.00.pdf
Page 152
Rob Hickman
Advanced Flight Systems Inc.