Is it possible to use the Dynon adapters with an AF2500?
Thanks,
Dave
Is it possible to use the Dynon adapters with an AF2500?
Thanks,
Dave
Is it as simple as cutting JP6 & JP7? Then use the 5V supply, ground, and tank connections to connect to the Dynon senders?
Dave
Correct, here is the official blurb :
To convert from FLOAT to CAPACITANCE style senders Cut the JP6 and JP7 jumpers found directly under the “Float Fuel” label on the rear of the PCB. Take care
not to damage the PCB and ensure the jumper is completely removed with ohmmeter.
Then recalibrate the system.