-
Senior Contributing Member
6cyl pmag config
I recently installed dual Pmags on my RV-10. Per Brad the pmag outputs three pulses per revolution. The install manual for the 5500 states to set the rpm setting to pulses per two revolutions, which would be 6. When start the engine for the first time, it appears that the rpm setting is doubled. At a low idle, it was showing about 2300 on both and about 2150 on either single mag.
I know that I wasn
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules