Hi Trevor,
How can I tell if the pre-installed AOA data on a 4500 is for an RV-7A?
Thank you,
/\/elson
Hi Trevor,
How can I tell if the pre-installed AOA data on a 4500 is for an RV-7A?
Thank you,
/\/elson
Anybody home?
RV-4, 6, 7, 8 Data
ZERO_LIFT_CRUISE, 67
PERFORMANCE_CRUISE, 680
APPROACH_CRUISE, 884
WARNING_CRUISE, 1242
CRITICAL_ANGLE_CRUISE, 1650
ZERO_LIFT_LANDING, -175
PERFORMANCE_LANDING, 599
APPROACH_LANDING, 779
WARNING_LANDING, 1310
CRITICAL_ANGLE_LANDING, 1826
AOA_AUDIO, 1
AOA_ENABLE, 1
LANDING_OVERRIDE, 80
USE_FLAP_ANGLE_SENSOR, 0
CRITICAL_AOA, 150
DECLUTTER_SEGMENT, 8
Rob Hickman
Advanced Flight Systems Inc.
Rob,
Can you provide the same data for the RV-10? Thanks
Thank you, Rob.
I have verified my setting are preloaded, however I have 3 parameters that are different. It is an RV7A.
My Zero lift setting is 68 (not 67)
My Landing Override is 8.0 (not 80)
My Critical AOA is is 15.0 (not 150)
The zero lift setting is close, the others are an order of magnitude off. Is this just a newer set of numbers or do I need to change to those to your posted settings?
Thanks
Roger
My Zero lift setting is 68 (not 67) Close enough
My Landing Override is 8.0 (not 80) 80 in the file is 8.0 on the screen it gets divided by 10
My Critical AOA is is 15.0 (not 150) 150 in the file is 15.0 on the screen it gets divided by 10
Rob Hickman
Advanced Flight Systems Inc.
The default preload for my RV-8 feels better then after the calibration. How can I load the settings listed above to get back to the factory configuration?