Can we get the dimensions for the area behind the panel required for the standard mount?
Looks like a standard hole with standard screw spacing. Height and width should be standard also.
Just need to know how far 'forward' it goes....
Thanks!
Can we get the dimensions for the area behind the panel required for the standard mount?
Looks like a standard hole with standard screw spacing. Height and width should be standard also.
Just need to know how far 'forward' it goes....
Thanks!
Hi recapen,
I used a combination of this and this to help with my layouts and hole spacing/drilling with good results.
Dimensions for the 2-1/4" round face AF-Pilot:
Face of the unit to the back of the aluminum enclosure: 5-3/8" (Note 1)
Face of the unit to the back of the plastic pitot/static block: 6-1/8" (Note 2)
Notes:
1 - Allow for an additional 2-1/2" for a standard DB-25 connector w/ shell and associated wires from the rear of the aluminum enclosure. This could possibly be as tight as 2-1/4" but could pose challendges w/ wire chafing and insertion/removal/securing of the DB-25 connector itself.
2 - Allow room for appropriate pitot/static connectors into the plastic block. Note that 1/8" NPT is used and should be hand-tightened followed by 1/2 additional turn to avoid cracking the block.
Good luck,
/\/elson
Thanks a bunch!