Rob
I saw on my about page of my 4500 that I am running version 3.7
On my Arinc adaptor. How can I update that to the latest version. On my
3400 EM it shows not installed.
Don
Rob
I saw on my about page of my 4500 that I am running version 3.7
On my Arinc adaptor. How can I update that to the latest version. On my
3400 EM it shows not installed.
Don
The latest ARINC software is with the current EFIS software.
http://advanced-flight-systems.com/S...cksupport.html
Rob Hickman
Advanced Flight Systems Inc.
Rob,
I did install the latest software again and after going into the about screen it still shows version 3.7
Don
Are you installing the ARINC software from the EFIS ADMIN, System Maintenance menu?
Rob Hickman
Advanced Flight Systems Inc.
When updating my 4500 I thought the Arinc software was included in the
Download and it would go to the Arinc while updating the 4500.
Is there another method for updating the Arinc separately?
Don
Looking in the manual and found (ARINC Module Software Updating)
Should I be updating my 3400 engine monitor with the Arinc software or just my 4500?
Thanks Rob
Last edited by Don Patterson; 01-06-2014 at 01:47 PM.
Don,
You would want to update the unit in which the the ARNIC unit is physically connected to update the ARNIC software. Then you would want to ensure that both the 4500 and 3400 are on the same version as well for optimal operation.
bob