Activity Stream

Your USB stick has become stuck mounted read-only which is preventing the EFIS from writing the daily system backup to the stick. Pull the stick out...

Figured it out. When flying to adjust the A/P parameters, go to SET, then AP/FD. Along the bottom of the screen is a button for each parameter to...

Thanks Jonathan. I'll send it in.

I guess you could try the 12V default emag signal in the 5V pin 32 RPM input, but spoiler alert, if your EFIS has anything but the newest hardware...

Thanks again. The wiring is already installed, so I’ll modify it myself.

This does not need to be run outside of the ACM. When we build a harness with Lemos we will tee off from the main power going to the audio panel: ...

Here are the results of the test. There is no resistor in series with the wire from the pmag. I started up and didn't have RPM. I do seeing counts...

Awesome, Thanks for the quick reply...two more questions: 1. I've installed LEMO plugs for the headsets and need to feed them power. I would like...

Correction: we do have a drawing. This drawing is not in our current ACM and Panel manual, but it will be in the next published revision. ...

Brian we only have drawings for the EX3.0 analog and EX3.0-S serial CO monitors. For wiring the Altus box on your oxygen system, you should run...

Vas, As Rob has related in reply to the above-referenced VAF thread, yes your screens can be upgraded to the latest intel CPU used in the AF-6600. ...

I have the same problem. I can adjust my HITS altitude with the bug when I have a direct to airport selected. If I use the FPL button to enter a...

Yes the RPM ground and power are only for the sensor that we make to install in a magneto. Is there a resistor in series with the wire from the...

Jonathan, I'm still not getting RPM while my FD180 works on either Pmag and a T-30 tach functions correctly. I'm curious about the RPM Ground that...

Thanks Jonathon! Easy enough when you know the fix… Bill

Hi Jonathon, Can we discuss the SkyFYX/EchoUAT issue a bit further? I've been feeding traffic data to my AF-4500 from a SkyFYX/Echo's serial...

SET --> EFIS --> FD DUAL / FD VBAR button will toggle flight director cue styles. SET --> AHRS --> PITCH ADJ --> and twist the joystick knob to...

What was your altitude when you entered and activated the destination?

I'd really like that feature too. I do have the IFD set up for that functionality on a user defined field, but then I have to put the VFPL into both...

I would favor that feature.

Thanks for responding Jonathon I originally tried the 12v mode on the each pmag using pin 33 the result was no rpm. I added diodes to each with the...