Sounds like you may have an older AFS ARINC module. If that is the case, upgrade to the Dynon SV-ARINC. If you already have the Dynon version, I would
rleffler Today, 06:14 AMIn the end it was not the wiring and it was not menu configurations. The software on my Dynon SV-XPNDR-261 was out of date. It was so out of date that
483RV Yesterday, 05:25 PMI have a AF5600 and a GTN650. The efis will draw all phases of the flight plan except the holding patterns and procedure turns.
Is this normal?
Transponder code reset after flight, option?
I too have failed to reset the xpndr code and did not catch it on the next flight I think two different times. I should probably re-write my checklist
benwestfall Today, 09:58 AM