1. RV6A
2. If I understand the question correctly, I believe the ground wire from the battery goes to the engine case. It was wired following Vans instructions.
3. I do not recall it reacting like...
Type: Posts; User: mgaffney
1. RV6A
2. If I understand the question correctly, I believe the ground wire from the battery goes to the engine case. It was wired following Vans instructions.
3. I do not recall it reacting like...
When I turn on the pitot heat the cylinder head temperatures go from 450 to 650 and the exhaust gas temperatures also go way up. To a lesser extent this will happen when I turn on the landing...
The fuel flow is either a Floscan 201A or 201B with 10 volts positive input. The manifold pressure sensor is hooked up and reads way low. Looks just like yours and I believe it is a GM car part. ...
I’m in the process of replacing my Rocking Mountain engine monitor with your unit and was wondering if their manifold press & fuel flow senders will work with your unit.
Thanks!
Tank 1 .03 volts
Tank 2 3.66 volts
Tank 2 is not yet calibrated but it seams to more or less work correctly. When fling on tank two the icon on the screen for the tank goes from full to empty as the full is consumed. The value for...
Trevor
I never had both the analog gauges hooked up at the same time with the EFIS. I was just trying to say that everything was working fine before the installation of the EFIS.
Thanks
Mike
Have a single 4500. When I turn it on without anything connected to back (no sensor input) the tank 1 AD_VALUE is 27 and tank 2 is 3668. When I connect the sensor wiring to the back of the 4500,...
Installed keys are: MAPPING AOA SYNTHETIC VISION
Other info is: 7.6.14-MV12, 1.12/4.1
OS Version is: 830
I currently have pages 2 (EFIS Only), 3 (EFIS & EMS) & 7 (Map & EMS) active
I have a single AF-4500 and wish to enable the EFIS, MAP, and EMS page but when I position the pointer to that option (number 6) and then turn the right knob either left or right, nothing happens and...