Search:

Type: Posts; User: danbenua

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Thread: GPS Antenna

    by danbenua
    Replies
    2
    Views
    294

    Thanks Jonathan! Just what I needed...

    Thanks Jonathan! Just what I needed...
  2. Thread: GPS Antenna

    by danbenua
    Replies
    2
    Views
    294

    GPS Antenna

    Which GPS antenna model is shipping with the IDF-540? I'm looking for the mounting hole diagram for that antenna.
    Thx!
  3. Replies
    1
    Views
    767

    "No GPS" and frozen moving map

    I need trouble shooting advice for my AF-5500. Three times today in flight I got a "No GPS" alert on the moving map and it
    froze at the present position. Other items on the map continued to...
  4. Replies
    6
    Views
    58,421

    Wing ports vs Dynon pitot

    When building, what are the pros/cons of the Dynon pitot AOA vs the old style wing pressure ports? Planning an AFS panel and I want to make the choice during the wing build.
    Thx,
    -Dan
  5. Replies
    2
    Views
    103,453

    FYI, I contacted uAvionix support. They said...

    FYI, I contacted uAvionix support. They said that I can feed the SV-GPS-2020 serial data directly into the echoUAT via pin 6. The echo will send traffic and weather data to the EFIS from its pin 3....
  6. Replies
    2
    Views
    103,453

    uAvionix echo UAT

    I'm considering replacing my AF-74112 with a uAvionix echo to get ADSB-Out. My system is AF-5500 + SV2020 + Trig TT21. Any red flags with his setup? What setting should I use on the serial port...
  7. Replies
    13
    Views
    23,646

    Capacitive senders are mentioned is on page 164...

    Capacitive senders are mentioned is on page 164 of the manual where users are advised
    to connect them to pins 20, 21 of the EMS. My opinion is that omitting the information
    that capacitive...
  8. Replies
    13
    Views
    23,646

    So are you saying that the installation...

    So are you saying that the installation instructions are wrong for capacitive senders?

    I think there are resistors in the lines to the converters. Would removing them
    help. Currently pin 22...
  9. Replies
    13
    Views
    23,646

    The sensor type is set to capacitive, but they...

    The sensor type is set to capacitive, but they are connected to pins 20 and 21 as shown in the installation manual.
    These were not changed when I upgraded from the 4500.
  10. Replies
    13
    Views
    23,646

    I am using the SV-EMS-220 and I specified...

    I am using the SV-EMS-220 and I specified capacitive senders when I ordered.
  11. Replies
    13
    Views
    23,646

    My converters have no external identification,...

    My converters have no external identification, but they were purchased from Van's in 2007. With the converters powered off, the AD values are about 2500. When
    power is applied, the AD values...
  12. Replies
    13
    Views
    23,646

    Capacitive Tank Senders

    I'm installing a new 5600 and have Princeton converters for my capacitive senders. My tanks
    were half full when I started, and AD values of about 1870. When I drained them to prepare
    for...
  13. Replies
    1
    Views
    6,219

    AF-5000 Install Documentation

    I'm setting up my new 5600 and the current software configuration options are not in sync with Version 5.4 of the Installation Manual.
    Any plans to release an update?
  14. Replies
    6
    Views
    14,246

    I don't have a touch screen unit. I still...

    I don't have a touch screen unit.

    I still confused about what is needed to upgrade to the SV-ADAHRS-200/201. It would seem that the
    only way to free up a serial port is to add the SVN network...
  15. Replies
    6
    Views
    14,246

    Thanks Shawn, Are you saying there is no way to...

    Thanks Shawn,
    Are you saying there is no way to do this without upgrading the screen for the SV network and replacing
    my AHRS and ADSB-in? Would my current setup work if the GPS-2020 was wired...
  16. Replies
    6
    Views
    14,246

    Serial Port Setup

    I have a 5500 and want to upgrade to ADSB-out with a SV-261; but that will
    require reconfiguration of my serial ports.

    My question is can I configure a serial port to send output to an...
  17. Replies
    2
    Views
    50,738

    Inflight Reboot

    During a flight last week I experienced two unprovoked reboots of my AF-5500.
    Both times the instrument recovered with no input from me, but after the
    second reboot there was an annoying "flashing"...
  18. Replies
    1
    Views
    7,134

    OAT sensor problem?

    On a long flight yesterday I saw that the OAT, TAS, and wind speed/direction indicators
    all showed "---" on my 5500 screen. All had been working on the previous flight. I suspect
    the OAT sensor,...
  19. Replies
    3
    Views
    8,735

    Thanks. Exactly where do I look to find out if...

    Thanks. Exactly where do I look to find out if my system needs to be sent back for wiring changes?
  20. Replies
    3
    Views
    8,735

    Pressure Sensor Issues

    I've been seeing intermittent issues with my fuel and oil pressure sensors on the 5500.
    Sometimes when the engine is cold, the pressures will read way high (like 45psi fuel,
    110 psi oil). ...
  21. Replies
    1
    Views
    7,200

    EFIS Reboot in Flight

    Yesterday my 5500 rebooted twice during operations; once while warming the engine before the first flight of the day and once on short final on the third flight. Both times the screen went black for...
  22. Replies
    7
    Views
    14,969

    Hi Rob, Thanks. I'm sure your point #2 will fix...

    Hi Rob,
    Thanks. I'm sure your point #2 will fix the ownship issue. Any suggestions on the text weather reception?
    -Dan
  23. Replies
    7
    Views
    14,969

    Hi Rob, Test flew the ADSB yesterday. Lots of...

    Hi Rob,
    Test flew the ADSB yesterday. Lots of traffic was displayed, and the About->WX page showed
    ground stations in site and lots of messages. The only annoyance was the near constant...
  24. Replies
    7
    Views
    14,969

    ADSB & TIS-A Traffic

    I have a Trig transponder that displays TIS-A traffic on my AFS 5500. Now I am installing the
    Dynon ADSB receiver. Is there any reason to keep my transponder traffic output connected to the
    5500...
  25. Replies
    4
    Views
    10,862

    User-defined waypoints

    Any plans to add user defined waypoints? It would be great if we could
    add them by lat/long or by radial/distance. I didn't spot this feature in
    the AF-5000 user guide.
    Thx,
    - Dan
Results 1 to 25 of 33
Page 1 of 2 1 2