Search:

Type: Posts; User: Bgill

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    1,379

    Hi Jonathon, I sent an e-mail in to the tech...

    Hi Jonathon, I sent an e-mail in to the tech contact site as well. I did try scrolling through the checklist pages and no success there either. This being the co-pilot screen it doesn’t get that much...
  2. Replies
    2
    Views
    1,379

    Map zoom on 5600 screen

    I have a dual 5600 screen setup and noticed yesterday that the co-pilot screen will not zoom with the knob/joystick. (Not sure what happened to the rest of the post)
    The pinch zoom works fine as...
  3. Replies
    2
    Views
    4,112

    Just wanted to circle back and close this one...

    Just wanted to circle back and close this one out. After talking with Scott, the data that was pre installed on my new unit was from the wing port AOA database and I am using the Dynon heated AOA...
  4. Replies
    12
    Views
    10,411

    MacCool, As the flaps deploy, does the % value...

    MacCool,
    As the flaps deploy, does the % value beside the AD value change uniformly with the AD value? I just went through a scenario that left me with flaps going from 0 at position 1 to 100% at...
  5. Replies
    2
    Views
    4,112

    As a followup to the original post, I did some...

    As a followup to the original post, I did some more editing of the values this morning and found that it is sensitive to the order of the position saved. I went back into calibration mode and set the...
  6. Replies
    2
    Views
    4,112

    Flaps Position Indicator & AOA readout

    Running an Advanced ACM panel with 5600 screens. Flaps controlled by stick switch and screen buttons. I just updated to SW version 16 with no change to my issue. The Flaps operate correctly with...
Results 1 to 6 of 6