Search:

Type: Posts; User: mgaffney

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    11,029

    1. RV6A 2. If I understand the question...

    1. RV6A
    2. If I understand the question correctly, I believe the ground wire from the battery goes to the engine case. It was wired following Vans instructions.
    3. I do not recall it reacting like...
  2. Replies
    9
    Views
    11,029

    cht, egt & amps

    When I turn on the pitot heat the cylinder head temperatures go from 450 to 650 and the exhaust gas temperatures also go way up. To a lesser extent this will happen when I turn on the landing...
  3. Replies
    3
    Views
    7,994

    The fuel flow is either a Floscan 201A or 201B...

    The fuel flow is either a Floscan 201A or 201B with 10 volts positive input. The manifold pressure sensor is hooked up and reads way low. Looks just like yours and I believe it is a GM car part. ...
  4. Replies
    3
    Views
    7,994

    Rocky Mountain Senders

    I’m in the process of replacing my Rocking Mountain engine monitor with your unit and was wondering if their manifold press & fuel flow senders will work with your unit.

    Thanks!
  5. Replies
    7
    Views
    244,748

    Tank 1 .03 volts Tank 2 3.66 volts

    Tank 1 .03 volts
    Tank 2 3.66 volts
  6. Replies
    7
    Views
    244,748

    Tank 2 is not yet calibrated but it seams to more...

    Tank 2 is not yet calibrated but it seams to more or less work correctly. When fling on tank two the icon on the screen for the tank goes from full to empty as the full is consumed. The value for...
  7. Replies
    7
    Views
    244,748

    Trevor I never had both the analog gauges...

    Trevor

    I never had both the analog gauges hooked up at the same time with the EFIS. I was just trying to say that everything was working fine before the installation of the EFIS.

    Thanks
    Mike
  8. Replies
    7
    Views
    244,748

    Fuel Tank Calibration

    Have a single 4500. When I turn it on without anything connected to back (no sensor input) the tank 1 AD_VALUE is 27 and tank 2 is 3668. When I connect the sensor wiring to the back of the 4500,...
  9. Replies
    3
    Views
    6,510

    Installed keys are: MAPPING AOA SYNTHETIC VISION...

    Installed keys are: MAPPING AOA SYNTHETIC VISION
    Other info is: 7.6.14-MV12, 1.12/4.1
    OS Version is: 830

    I currently have pages 2 (EFIS Only), 3 (EFIS & EMS) & 7 (Map & EMS) active
  10. Replies
    3
    Views
    6,510

    AF-4500 Screen Selection Set Up Issue

    I have a single AF-4500 and wish to enable the EFIS, MAP, and EMS page but when I position the pointer to that option (number 6) and then turn the right knob either left or right, nothing happens and...
Results 1 to 10 of 10