Results 1 to 5 of 5

Thread: Mounting 5600 to Aerosport panel

  1. #1

    Mounting 5600 to Aerosport panel

    Doesn't look like the second bulkhead needs to be cut away for symmetrical panel but wondering about the alum panel insert the 5600 mounts to, much of that gets cut away for finish cut. Does that require some alum angle around the perimeter of the vertical edges? Or should all the screws holding the insert be sufficient? Similar to Robs installation--wondering what was done there?


    Dave Ford
    RV10
    Aerosport Symetrical panel

  2. #2
    I just have the aluminum panels with press in nuts for the EFIS screws.
    Rob Hickman
    Advanced Flight Systems Inc.

  3. #3

  4. #4
    Does that require some alum angle around the perimeter of the vertical edges?
    Usman

  5. #5
    You don't need any aluminum angle. The AeroSport aluminum inserts get screwed through the carbon panel into the aluminum sub panel.
    Rob Hickman
    Advanced Flight Systems Inc.

Similar Threads

  1. AeroSun VX Wiring with Quick Panel
    By TuppRV7 in forum AF-5000 Install Schematics
    Replies: 3
    Last Post: 10-15-2018, 04:32 PM
  2. AFS Autopilot Interface Panel
    By rvdave in forum General Discussion
    Replies: 3
    Last Post: 12-14-2015, 03:28 PM
  3. TWTT Sportsman Panel Upgrade
    By bigbird in forum AF-3400s, AF-3500s, AF-4500s ... General Discussion
    Replies: 1
    Last Post: 08-16-2015, 08:58 PM
  4. 5800 Panel Cut
    By lcbowen in forum AF-5600 & AF-5500 General Discussion
    Replies: 0
    Last Post: 03-10-2013, 08:57 AM
  5. mounting Cisco / Linksys SD 205
    By tomhanaway in forum EFIS Installation Questions
    Replies: 1
    Last Post: 06-01-2010, 07:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •