Airport diagrams and plates

[rvdave]

I have loaded the Seattle charts diagrams, plates on usb stick and I can load all data to display but when switching from map or sectional or ifr low back to airport diagram it doesn't remember the last airport diagram viewed in fact it defaults to one that it can't find. I have to go back to fltpln, info to load the airport diagram again. The plate defaults back to the destination airport at the end of fltpln, is this normal?

[Shawn McGinnis]

The AIRPORT button will attempt to bring up the last airport in the flight plan with a valid image or the nearest airport that has a valid image available.

[rvdave]

Not flying yet and not quite yet ready to roll plane out of the hangar so don't have active gps signal so that makes sense why it's not picking up nearest airport diagram but it does remember last approach plate in the fltpln. Will wait to see what happens with signal.