Results 1 to 2 of 2

Thread: RPM indication for Rotax 912

  1. #1

    RPM indication for Rotax 912

    starting to get to the pointy bit of wiring, how does the 2500 analog module interface with the Rotax 912 tach signal wires.

  2. #2
    Advanced Flight Systems Shawn McGinnis's Avatar
    Join Date
    Sep 2012
    Location
    Canby, OR
    Posts
    861
    The 912 can be interfaced to the 2500 using our 71,420RX RPM Interface board. Call us at 503-263-0037 x 2 for ordering.

    The Rotax engines have a 5th trigger coil for RPM monitoring. The trigger coil outputs on a two wire harness. Connect one of the two wires to ground and the other to the supplied 33Kresistor, the other end of the resistor than connects to the P/N: 71420 R Rotax RPM interfaceboard yellow wire. The Rotax RPM interface board is a small heat shrunk module and shouldbe secured on the inside of the aircraft. If you are using the P/N:71420RX you do not need toinstall the 33K resistor.
    Shawn McGinnis

    Advanced Flight Systems
    support@advanced-flight-systems.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •