I purchased a POS-12 to measure the flap position for the AOA to work with the AF-3500. The POS-12 has 3 wires. What do they get hooked to on the aF-3500?
I purchased a POS-12 to measure the flap position for the AOA to work with the AF-3500. The POS-12 has 3 wires. What do they get hooked to on the aF-3500?
Look at the EMS wiring diagram, it's on there. One wire is power, one is ground, one is position. If you don't have an engine monitor capable EFIS I think you're out of luck....
Ref: Engine Sensor Harness Wiring Diagram (Page 78 of the current manual - V6.6 on our website)
Pin 2 - Trim Power
Pin 3 -Trim Ground
Pin 34 - Flap Position
Thanks guys. I didnt even look at that page. Forgot all about it. all my other wires were hooked up that way months ago. go figure huh.
I think I read somewhere that with the POS 12 installed, there is no requirement to install the AOA micro-switch for flap positions. Is that a true statement?
Terry
Yes that is true. if a POS-12 is installed there is no need for the flap switch.
Jim Shannon
RV-8 N52VV
Charlottesville, VA