To have full control of the AF-Pilot from the EFIS you need to connect both TXD and RXD to the EFIS and not the 430W
To have full control of the AF-Pilot from the EFIS you need to connect both TXD and RXD to the EFIS and not the 430W
Rob Hickman
Advanced Flight Systems Inc.
Rob, since the AFS-Pilot only has a single serial port (two pins - one TX, the other RX), I am unclear how to add this AP control capability while maintaining the current 430W connectivity as recommended in your wiring diagram.
Can you please provide a revised wiring diagram?
Highest Regards,
Noah F
RV-7A
Rhode Island
Rob Hickman
Advanced Flight Systems Inc.
Any developments on the non-unique identifiers chaps?
I guess that's a "No" then.
Correct, nothing yet.
Just how long is this going to take?
I guess the ability to deal with non-unique identifiers is not happening?
This is a problem with the underlying data format that we are working on. It is a problem in both the AF-4500 and AF-5000 systems, we are working on the new data format and will have a solution.